- Printed on: Bambu Lab X1 Carbon
- Using Filament: PLA
- Printed Without Supports
- Infil: 15%
- Walls: 2
- Layer: 0.2 mm
- Author: MatthewGhost (Maker World)
In certain instances, the spacer turned out to be too loose. To address this, additional clearance is provided to ensure the dial turns smoothly. However, since each printer has varying tolerances, I suggest adjusting the spacer’s width in the slicer. Increase it incrementally, aiming for a fit where the spacer is neither too loose nor too tight, allowing the dial to move freely. (An increase of +0.1 mm per step is recommended.)
