- Printed on: Prusa MK4
- Using Filament: Silk PLA+
- Printed Without Supports
- Infil: 15%
- Walls: 2
- Layer: 0.2 mm
- Author: Whale3Dstudio (Cults)
This is a model of the Cube Gear Fidget Toy, designed to help alleviate stress when played with.
If the plastic you’re using is somewhat rigid, you may find it tricky to assemble the joints. Don’t worry—using a hair dryer to warm and soften the material will make it easier to connect.
No additional supports are necessary for this model, as it is a print-in-place design. However, you can add a brim to improve adhesion to the print bed.
